Solid teak wood, with its high natural oil content (approximately 10-15% by volume) and dense grain structure (specific gravity typically 0.6-0.7 g/cm³), offers superior resistance to UV radiation and moisture absorption compared to many synthetic materials like plastics or composite woods. While plastics can become brittle and chalky under prolonged UV exposure (often exceeding 1000 hours), teak's natural oils act as a protective barrier, slowing degradation. Over five years in typical outdoor conditions, teak may develop a silver-gray patina but retains structural integrity, whereas lower-quality synthetics might experience significant color fade or material breakdown.

The electroplating process on the hook and ring provides a protective layer, typically a few microns thick, over a base metal like steel. For everyday use in dry or moderately humid environments, this finish can last 2-4 years before signs of wear, such as minor pitting or surface discoloration, become apparent. However, if the game is left outdoors continuously and exposed to frequent rainfall (over 50 inches annually) or high humidity (>80% RH), the unprotected areas or edges of the plating might show rust spots within 1-2 years. Regular drying and occasional application of a light lubricant can extend the plating's effective lifespan by preventing moisture ingress.

The 3.5-pound static weight of the game is less critical than the dynamic forces generated during play. When a player swings the ring, forces can exceed 5-10 times the static weight. Therefore, mounting on standard 1/2-inch drywall without adequate support is not recommended, as it typically only supports 10-20 pounds for static loads and far less for dynamic ones. Secure installation requires anchoring into solid wood studs (spaced 16 or 24 inches apart), solid masonry, or using heavy-duty toggle bolts rated for at least 50 pounds shear and pull-out strength to prevent the unit from detaching from the wall during active use.

The foldable arm mechanism relies on a pivot point, likely secured by screws or a bolt. While the teak wood construction is solid, the longevity of the folding mechanism depends on the quality of the hardware and its resistance to environmental factors. In dusty conditions, fine particles can infiltrate the pivot, increasing friction and wear. In humid environments, corrosion can affect metal components within the hinge. With regular use (e.g., daily folding/unfolding), and without periodic cleaning or lubrication (e.g., a light coat of marine grease every 6 months), the pivot might develop stiffness or minor play after 500-1000 cycles, potentially affecting the smoothness of the fold and unfold action.